QuickStart: FLIR/EXTECH i3, i5, i7
© 2011 The Snell Group / 322 N. Main Street / Suite 8 / Barre, VT 05641 / 800-636-9820 / www.thesnellgroup.com
FLIR/EXTECH i3, i5, 17 Page 1
Fig.1
Memory Power Data
Charge Indicato
1. MEMORY: Insert a miniSD card into the slot under the rubber Memory/Charge/Data
cover on the side of the handle (Fig.1).
2. POWER:
Slide the battery access cover down to open, connect the battery’s cable
connector to the camera’s internal connector, insert the battery and replace
cover.
The battery must be charged inside the camera by connecting the power supply to the center port under the
Memory/Charge/Data cover (Fig.1).
Once plugged in the battery charging indicator LED will change from orange to green when the battery
is fully charged.
3. START: Press the On/Off button to power the camera on or off.
4. FOCUS: The i-series is a fixed focus camera with no adjustment needed. IMPORTANT NOTE
: Minimum focus
distance = 24 inches.
5. AUTO ADJUST: In Auto mode the i-series will continuously auto adjust both
Level and Span (Brightness and Contrast.
To switch between Auto mode and Manual (or Locked) mode, press the
Right Selection Button.
No padlock icons (Fig.2) will appear on the lower portion of the LCD when the camera is in Auto Adjust
mode.
6. MANUAL ADJUST: When entering into manual (Locked) mode, Level and
Span are locked at their current settings.
If in Auto mode press the Right Selection Button to switch to Manual
(Locked) mode.
Padlock icons will now be displayed on the LCD (Fig.3).
Fig.2
Fig.3
Trigge
Battery
Access
Cover
Memory,
Charge & Data
Cover
Lens Cap
Lever
Fixed Focus
Lens
Left Selection
Button
Archive Button
On/Of
Navigation Pad
( up[+]/down[-]/left/right)
Right Selection
Button
LCD
+
-
Right Selection
Function
Left Selection
Function
Spot Temp.
To Next Page
Need help?
General
