910-0001-00-MAN-R06 FLIR Proprietary Information Page 63 of 81
Information contained in this document pertains to a Canadian origin product that is controlled as "dual use" by the Canadian
government. However, when in the United States or possessed by a US person, it may be considered a defense article from the US Government's
perspective. US government authorization may be required for re-transfer to a foreign person. If you have any questions, please contact FLIR's
Global Trade Compliance group at exportquestions@flir.com .
2.2.8.3 Radar Control: STBY / XMIT Commands
The radar is set in transmission and standby mode by right clicking with the mouse on the desired radar
icon, and selecting STBY (standby) or XMIT (transmit). Figure 53 shows the menu used for Standby and
Transmit commands.
Figure 53 - Radar Standby and Transmit Commands
The Reset Radar Unit command allows you to reset the radar. This command is accessed the same way
as Standby and Transmit commands (refer to Figure 53). During the reset (approximately 30 seconds),
the radar will not transmit RF energy or detect targets.
The Loader command allows you to load new radar firmware. When this command is selected, the user
will be prompt to select the radar firmware file.
To Next Page
Loading...