14
USER MANUAL # 4204190 - Rev 1
Notication screen of a successful load and pending
restart to nish software update
Loading bar progression in SCOUT TK eyepiece
9) It will take approximately 5 minutes for the software to load. The
camera will restart when the process is complete
5.2 BATTERY SERVICE AND REPLACEMENT
If the battery will not hold a charge and requires replacement,
please contact FLIR Systems for details on returning the unit
for service. For instructions on charging the battery refer to
Section 2.3 Charging the Camera.
5.3 CLEANING THE SCOUT TK
Wipe the housing with a damp cloth as needed. Use a high
quality lens wipe to remove dirt or smudges from the lens and
display window. Do not use abrasives or solvents to clean the
housing, lens, or display window.
5.4 OVER TEMPERATURE PROTECTION
The camera has built in over temperature protection to
prevent damage to the electronics. When an over temperature
condition is detected the image below is displayed for ten
seconds before the Scout TK shuts down. After a thermal
shutdown, the Scout TK will not turn on until the camera’s
interior has returned to a safe operating temperature.
Excessive Temperature warning
1.800.561.8187 info@FLIR-Direct.ca
FLIR-DIRECT.ca
To Next Page
Loading...
Need help?
Display
Power
Operating Environment
Weight and Dimensions
