40
Engage the Motor and get moving
1 Climb onto the board, taking care not to kick the hydrofoil wings
or mast.
2 Lie on the board, positioned so that you can touch the front of the
Fliteboard with your hand (or the front handle if using the Fliteboard AIR).
3 Verify Flite Controller is set so you see power level ’1’ displayed on
the lock screen. This is your starting power setting once unlocked
(it can be changed later if you are an advanced rider).
4 Arm the motor and squeeze the throttle trigger. The board should
start to move. You should be on power level 1 (a low power setting).
5 Practice riding lying on the board and changing speed using the
buttons between level 1 and level 3. Be sure to keep enough weight
on the front of the board to keep the nose of the board down and
parallel to the water.
PRO TIP Fliteboard has been designed with a cruise control system
in mind. Squeezing the trigger all the way in makes it easier to use your
thumb to change the speed (from level 1 to 20). As you accelerate you
may need to shuffle forward to keep the nose down.
1
2
3
To Next Page
Loading...