Why is my Flo Fab Water Pump motor overloading?
Motor overload in your Flo Fab Water Pump can be due to several reasons: * **Low Voltage:** Ensure the voltage supply is correct. * **Overload:** Verify that the amperage isn't exceeding the plate's limit. Check for any foreign material forcing the impeller and confirm the motor is suitable for the pump.
How to fix a noisy Flo Fab Water Pump?
A noisy Flo Fab Water Pump can stem from several issues: * **Loose Pump Base:** Ensure the screws at the base are tight and check for cracks. * **Cavitation:** Make sure the dynamic level isn't too high, the pumping capacity isn't excessive, and the pump operates within the NPSHR range. Partially closing the discharge valve might resolve the noise. * **Bearings:** Inspect the bearings for wear and ensure there's oil in the deposit. * **Vibration:** Verify the impeller is free of foreign material, the pump operates within range, and the alignment is correct.
What to do if Flo Fab Water Pump loses its priming during operation?
If your Flo Fab Water Pump loses its priming during operation, with the vacuum gauge dropping to zero, consider these potential causes: * **Suction dynamic level too high:** Ensure the pump never lacks water in the suction during operation. * **Air Suction:** Check for leaks in the suction piping, flanges, and gaskets. * **Vortex Effect:** Confirm there's no vortex effect at the end of the suction, which could cause a lack of water.
General| Brand | Flo Fab |
|---|---|
| Model | 1000/1004-IC11/2H Series |
| Category | Water Pump |
| Language | English |
To Next Page
