Floorpul ruby 48 blt - Page 16

RECOMMENDED BRUSHES
Brushes must be chosen depending on type of floor and dirt to be removed.
The employed material and the bristles diameter are the elements that distinguish different types of brushes.
MATERIAL CHARACTERISTICS
PPL (Polypropylene) Good wear resistance. Maintains characteristics with hot water up to 50°C. It is not hygroscopic.
NYLON Excellent wear resistance, even with hot water. It is hygroscopic.
TYNEX
Nylon bristles with grains of abrasive material. Use with caution in order not to mark the floor or ruin the
polishing.
BRISTLES THICKNESS Thicker bristles are more rigid and must be used on smooth floor or floor with small joints. On irregular floors
with deep joints or relieves, it is recommended to use softer bristles which penetrate more easily and deeper.
Please be aware that when brush bristles are worn out and therefore too small, they become rigid and unable to
penetrate and clean deeper. This may also happen with thicker bristles creating brush vibration.
PAD HOLDER It is equipped with anchor points which permit the blocking of the abrasive pad during work. The pad is
recommended to clean smooth floors.
MACHINE CODE QUANTITY
DESCRIPTION
USE
ruby 48 blt
48902010
1
Brush PPL 0,3 Ø 508
Irregular floors with large joints.
48902020
1
Brush PPL 0,7 Ø 508
Smooth floors with small joints and persistent dirt.
48902030
1
Brush PPL 0,9 Ø 508
Smooth floors with small joints and persistent dirt.
48902040
1
Brush TYNEX Ø 508
Floors of resistant material and particularly dirty.
48902050
1
Brush PPL 0,6 Ø 508
Normal floors.
48902060
1
Brush 5-mix Ø 508
For all types of floors.
48802010
1
Pad holder Ø 495 + center lock green
For pads of 20”, for smooth surfaces cleaning.
48802020
1
Pad holder Ø 495 + center lock black
For pads of 20”, for smooth surfaces cleaning.