2
Regulaons
FloPlast’s Air Admiance Valve , if installed, used and maintained in accordance with this document and supporng
installaon guides, can contribute to sasfying the relevant requirements of the following Building Regulaons (the
presence of a UK map indicates that the subject is related to the Building Regulaons in the region or regions of the UK
depicted):
The Building Regulaons 2010 (England and Wales) (as amended)
Requirement: H1
Comment:
Regulaon: 7
Comment:
Foul Water Drainage
The valves will:
1. Provide adequate venlaon to prevent the loss of water seals in trapped appliances.
See secon 4, 6 and 7 of this document.
2. Prevent foul air from entering the building. See secon 7 of this document.
3. Enable access to sanitary pipework for clearing blockages. See secon 6.1 of this
document.
4. Contribute to the venlaon of underground drains. See secon 6.2 and 6.3 of this
document.
Material and workmanship
The products are acceptable. See secon 9 amd the installaon part of this document.
The Building (Scotland) Regulaons 2004 (as amended)
Regulaon: 8(1)
Comment:
Regulaon: 9
Standard: 3.7
Comment:
Standard: 7.1[a](b)
Comment:
Regulaon: 12
Comment:
Durability, workmanship and tness of materials
The use of this product sases the requirements of this Regulaon. See secon and the
installaon part of this document.
Building standards applicable to construcon
Wastewater drainage
The valves can meet the relevent requirements of this Standard, with reference to
clauses 3.7.7
(2)
and 3.7.1
(1)
. See secons 4, 6.1 to 6.4, 6.6 to 6.9 and 7 of this document.
Statement of durability
This product can contribute to meeng the relevant Requirements of Regulaon 9,
standards 1 to 6 and therefore will contribute to a construcon meeng a bronze level of
sustainability as dened in this standard.
Building Standards applicable to conversions
All comments given for product Regulaon 9, Standards 1 to 6 also apply to this
Regulaon with reference to 0.12.1
(1)(2)
and schedule 6
(1)(2)
.
The Building Regulaons (Northen Ireland) 2012 (as amended)
Regulaon: 23 (a)(i)(iii)(b)(i)
Comment:
Regulaon: 79
Comment:
Fitness of materials and workmanship
The products are acceptable. See secon 9 and the installaon part of this document.
Material and workmanship
The products are acceptable. See secon 9 amd the installaon part of this document.
Drainage Systems
The products provide adequate venalon to maintain water seals in traps. See secons
4, 6.1 to 6.4, 6.6 to 6.9 and 7 of this document.
Construcon (Design and Management) Regulaons 2015
Construcon (Design and Management) Regulaons (Northern Ireland) 2016
Informaon in this document may assist the client, designer (including Principle Designers) and contractors (including
Principle Contractor) to address their obligaons under the regulaons.