- 2 -
GENERAL SAFETY INSTRUCTIONS
WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result in electrical
shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
WORK AREA
• Keep your work area clear, clean and well lit. Cluttered work surfaces and dark areas invite accidents.
• Keep people not involved in the work, especially children away from the work area while operating a power
tool. Distractions can cause you to lose control of the tool.
• Do not operate power tools in an unsafe environment such as explosive atmosphere, flammable liquid,
gasses and dust. A spark created by a power tool may ignite the fumes or dust.
ELECTRICAL SAFETY
• Double insulated tools are equipped with a polarized plug (one blade is wider than the other.) This plug will fit
into a polarized outlet only one way. If it does not fit fully in the outlet, reverse the plug and try again. If it still
does not fit fully, contact a qualified electrician to install a polarized receptacle. Do not modify the plug in any
way. Double insulation eliminates the need for the three wire grounded power cord and grounded electrical system.
• Avoid body contacting with grounded surfaces such as radiators, pipes, ranges and refrigerators. There is an
increased risk of electrical shock if your body is grounded.
• Do not operate power tools in the rain or wet conditions. Water entering a power tool increases the risk of
electrical shock.
• Do not stress the power cord. Never carry the power tool by the cord or disconnect the plug from the
receptacle by yanking on the cord. Keep cord away from sharp edges, heat, solvents and oil. Replace
damaged cord immediately. Damaged cords increase the risk of electrical shock.
• Use outdoor extension cords when operating the power tool outside. Outdoor power cords are marked “W-A”
or “W” and are rated for outdoor use. These cords reduce the risk of electrical shock.
PERSONAL SAFETY
• Dress appropriately. Do not wear loose clothing or jewelry. Keep long hair in place and contained. Keep
clothing, hair and gloves away from moving parts. Loose clothing, jewelry and hair can be snagged in moving
parts.
• Use common sense, stay alert and watch what you are doing while operating a power tool. Do not use tools
while under the influence of alcohol, medication, or drugs. Keep focusing on the work at hand while using a
power tool to prevent personal injury.
• Make sure the power switch is in the “OFF” position before plugging it into the receptacle. This will prevent
accidental starting. Carrying tools with your finger on the switch or plugging in the tools with the switch in the “ON”
position invites accidents.
• Remove adjusting tools such as wrenches or keys before turning the tool on. A wrench or key left attached to a
rotating part will fly off and may cause personal injury.
• Do not overreach while operating a power tool. Keep proper footing and balance at all times. Good balance
and solid footing enables better control in unexpected situations.
• Always wear appropriate safety equipment. Always wear eye protection while operating a power tool. Use
appropriate dust respirators, hearing protection, hard-hat, face shield or safety shoes as dictated by the work and tool.
TOOL’S USE AND CARE
• Secure the work piece with clamps or other practical methods to provide a secure work platform. Holding the
work by hand or against your body is not secure and may lead to loss of control.
• Use the correct tool for the work. The proper tool will do the work faster and safer.
• Do not use the tool if the “ON/OFF” switch is not working. Operating a tool that cannot be controlled by you is
dangerous and must be repaired before use.
• Always disconnect the power cord from the electrical receptacle before storing the tool, making adjustments
or adding/replacing accessories. This simple prevention will reduce the risk of accidental starting of the tool.
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn
To Next Page
Loading...