FLOS TOIO - Page 22

22
WARNING! When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
For the installation of the spare-part, it is necessary to consult a qualified electrician.
©2021 Flos - All rights reserved - www.flos.com
Flos reserves the right to introduce any changes to its own models, without prior notice.
EN
Fig.3
RF17929
TRANSFORMER
REV. 2
DATE 25/11/2021
TOIO F7600035
On the lamp base (C), unfasten by utilizing a long type screwdriver (C), the 4 fixing screws (A) with
relative washers.
Remove the damaged transformer (D) from the lamp base (C).
Assemble now the new spare-part:
Collocate the new transformer (D) on the lamp base (C) and then fasten the 4 screws (A) with there
apposite washers.
Connect the plug (F) to the socket (G) of the transformer.(Fig.2 page 21)
Connect the plug (I) to the socket (L).(Fig.1 page 20)
A
D
C