41
WARNING! When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
For the installation of the spare-part, it is necessary to consult a qualified electrician.
©2021 Flos - All rights reserved - www.flos.com
Flos reserves the right to introduce any changes to its own models, without prior notice.
EN
REV. 2
DATE 25/11/2021
Fig.5
Fig.6
Remove the cable clamp (Fig.5) and
disconnect the cables from the green terminal
box.(Fig.6).
Assemble now the new dimmer:
Connect the cables respecting the polarities,
lock the wires by positioning the cable clamp
and then fasten the three screws, cover the
green terminal box with the triangle cover,
turn the dimmer box, fasten the screw and
stick-on the rubber pads.
TOIO F7600035
RF24160
BLACK 300W 220V-240V RONDÒ DIMMER
To Previous Page
Loading...
