Flow-Rite QWIK-FILL MP-2000 User Manual

Operaon
Typical Installaon Conguraons
Important
Baeries should only be lled aer
charging.
1
Insert the squeeze bulb ller assembly
into a jug of dislled water. Prime bulb by
squeezing unl it is lled with water.
2
Remove the dust cap from the water
supply line and connect it to the squeeze
bulb ller assembly by snapping the quick
couplers together.
4
Immediately disconnect the squeeze bulb
ller assembly from the water supply line
and replace the dust cap.
3
Squeeze the bulb with rm pressure to
begin pumping water into the baery cells.
When the bulb becomes hard, all cells are
full.
5
Any water remaining in the squeeze bulb
ller assembly may be pumped back into
the dislled water jug.
BL-186
11/11
Flow-Rite Controls • 960 74th St., Byron Center, MI 49315 • phone: 616-583-1700 • fax: 616-878-5151 • www.ow-rite.com
Patent Pending
Note: For general winterizing, drain excess water in water supply line by pushing the spring loaded buon on the end of the line. To
remove the clear tubing (if necessary), pinch the tubing next to ng, carefully twist and pull straight o.
The diagrams below show typical baery arrangements and how they might be plumbed with Qwik-Fill. The leers below each diagram
indicate which Qwik-Fill Kits would be required for that conguraon. Although the tubing between baeries can be up to a distance of 8’, it
may be more desirable to have separate ll points in the front and rear of the boat.
Fill Point
Battery
Required kit

Flow-Rite QWIK-FILL MP-2000 Specifications

General

Brand	Flow-Rite
Model	QWIK-FILL MP-2000
Category	Irrigation System
Language	English