Fully charge the battery prior to rst operation.
NOTE: The ashing red light on charger indicates that
battery is charging and once it turns green, the battery is
fully charged.
Fill the tank with pre-prepared liquid through
the intake lter and securely tighten the
tank cap.
NOTE: Always mix liquid solution in a separate
container.
Determine which nozzle is right for the job
& connect to spray wand by pulling down on
quick-connect and inserting nozzle.
a) Adjustable nozzle = ranges from jet stream to
conical stream
b) Fan nozzle = at 25º stream
c) Jet nozzle = narrow stream
Turn pump on by ipping switch on side of unit.
Flipping switch to “I” will activate pump at 60
psi. Meanwhile, “II” will activate at 45 psi.
Begin spraying by squeezing spray trigger.
1.
Preparing to spray:
STEP 2.
2.
3.
4.
5.
1.
2.
3.
4.
5.
a)
b)
c)
4
Copyright © WESSOL, LLC
To Next Page
Loading...
