FLTR Tekleen GB6 - User Manual

Mount controller on wall/panel or directly on filter.

Connect PD gauge tubing and wires to controller housing.

Connect 120/230 VAC to transformer wires for AC models.

Wire the 24VAC electric ball valve to controller terminals.

Set periodic backwash cycles from OFF to 24 hours.

Set filter backwash duration between 4 to 12 seconds.

Time between successive filter flushes for multi-filter systems.

Controls power to the controller and all filter components.

Displays backwash counter and fuse status.

Activates back flushing of the filter(s) manually.

Resets the back flush counter.

Resets the alarm output activated by consecutive backwashes.

Controllers operate at 120/230 VAC or 12/9 VDC.

Fuse for electronics, located between front panel and circuit board.

Connects power supply from transformer using two red and one white lead.

Controls the valve assigned as valve #1.

Controls the valve assigned as valve #2.

Output ON at backwash start, OFF at idle; for pressure sustaining.

Terminals for alarm output with two logic versions.

Terminals for the PD gauge; polarity is not important.

Built-in 30-second delay before first backwash to avoid false triggers.

Important warnings on output ratings, voltage settings, and connections.

Advice on controller placement, surge protectors, and mini-filter maintenance.