SAFETY INFORMATION
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment .This equipment should be installed and operated with minimum distance 20cm between the
radiator & your body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
FIRST TIME SET UP
Step 3: Attach same subwoofer cable to the
subwoofer output of your home theater receiver.
Step 4: Connect power cable to wall outlet. Set
power switch to either ON or AUTO ON.
OPTIONAL STEP:
Attach speaker wire to the speaker inputs of
the subwoofer. Attach same speaker wire to
the channel outputs of your choice on the
home theater receiver.
Refer to receiver manual for setup instructions.
Step 1: Place the subwoofer in the most optimal
position.
Fluance recommends having the woofer
face the listener while being positioned near the
front channel speakers in a corner if possible.
Step 2: Attach the subwoofer cable to the
LFE/Low Level Input of the DB10.
DB10 Receiver
SPEAKER OUTPUT
To Next Page
Loading...
