What to do if there's increased dirt concentration on the clean side of my Fluid Filtration Water Filtration Systems?
If you notice an increased concentration of dirt on the clean side of your Fluid Filtration Water Filtration System, it could be due to a defective filter element or brittle seals. Inspect the filter element and seals, and replace them if needed.
Why is the initial differential pressure no longer obtained in my Fluid Filtration FG AF 72 G?
If the initial differential pressure is no longer obtained in your Fluid Filtration Water Filtration System, it could be due to several reasons. The solids concentration might be too high, so improve the pre-filtration process. Alternatively, the gear motor might be rotating in the wrong direction, so check its rotation. It's also possible that the cleaning time is too short; try prolonging the cleaning time, ensuring the gear motor speed is at least 1-2 revolutions.
What to do if the valve does not open on Fluid Filtration FG AF 72 G Water Filtration Systems?
If the valve on your Fluid Filtration Water Filtration System isn't opening, it could be due to low compressed air pressure; try increasing the pressure. Another possibility is a defective pilot valve, which you should check. Also, ensure the pilot valve is correctly connected, verifying both electrical and pneumatic connections.
How to fix a gear motor that won't turn in Fluid Filtration FG AF 72 G?
If the gear motor on your Fluid Filtration Water Filtration System isn't turning, it might be due to a tripped motor fuse. In this case, reset the motor fuse. Alternatively, the filtrate might have solidified, so you should clean the filter.
What to do if the leakage rate at the shaft seal is too high in Fluid Filtration Water Filtration Systems?
If the leakage rate at the shaft seal of your Fluid Filtration Water Filtration System is too high, tighten the shaft seal. If the issue persists, replace the seal.
Instructions for personnel involved in installation and operation.
Explains the structure of warnings used in the manual.
Details the meaning of various warning symbols.
Information about the manufacturer.
Details about the instruction manual.
Information on the ATEX rating plate.
Explains the filtration and cleaning process.
Lists and illustrates the main parts of the filter.
Detailed explanation of how the metal-edge filter works.
Technical specifications relevant to specific orders.
More order-specific technical data.
Procedures for physically mounting the filter.
Specific guidance for installing the drain pipe.
Instructions for electrical/pneumatic connections, including customer/FG control.
Details time-controlled, differential pressure-controlled cleaning and draining options.
Steps to perform functional tests after installation.
How to program and configure the filter's operational settings.
Steps for temporary shutdown.
Procedures for extended shutdowns.
Instructions for emergency shutdown procedures.
Schedule for inspecting and maintaining the filter.
Step-by-step guide to safely remove the filter insert.
Instructions for cleaning the filter insert and casing.
Procedures for replacing the filter element.
Instructions for replacing the scraper component.
Guide to replacing the stuffing box.
General| Brand | Fluid Filtration |
|---|---|
| Model | FG AF 72 G |
| Category | Water Filtration Systems |
| Language | English |
To Next Page