Need help?Do you have a question about the Fluke TS19 and is the answer not in the manual?
Redials the last dialed number, up to 18 digits, via the LNR button.
Red LED indicates line polarity connection status.
Three-position switch for monitoring (HI Z, RING) and talk modes.
Selects between PULSE dial or TONE (DTMF) signaling output.
Cord with modular plug and piercing pin alligator clips.
Standard cord with modular plug and banana jacks/adapters.
Line monitoring in HI Z mode without disrupting traffic.
Verifies line polarity using the red LED indicator.
Procedure for placing calls using PULSE or TONE modes.
Automatically redials the last dialed number using the LNR button.
Controls the electronic ringer for incoming calls.
Instructions for replacing the belt clip assembly.
Steps for replacing the modular line cord.
Redials the last dialed number, up to 18 digits, via the LNR button.
Red LED indicates line polarity connection status.
Three-position switch for monitoring (HI Z, RING) and talk modes.
Selects between PULSE dial or TONE (DTMF) signaling output.
Cord with modular plug and piercing pin alligator clips.
Standard cord with modular plug and banana jacks/adapters.
Line monitoring in HI Z mode without disrupting traffic.
Verifies line polarity using the red LED indicator.
Procedure for placing calls using PULSE or TONE modes.
Automatically redials the last dialed number using the LNR button.
Controls the electronic ringer for incoming calls.
Instructions for replacing the belt clip assembly.
Steps for replacing the modular line cord.
General| Type | Telephone Test Set |
|---|---|
| Power Source | 9V battery |
| Continuity test | Yes |
| Voltage test | Yes |
| Polarity Indication | Yes |
| Talk Battery | Yes |
| Battery Test | Yes |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
To Next Page
