Flux Basic Series - Speaker Positioning; Choosing Optimal Locations

Positioning & Choosing a Location
POSITIONING
A component speaker system gives you the ability to place the woofer and
tweeter separately in your car. This can be good or bad depending on how
it’s done.
The tweeter should be placed relatively close to the woofer for best tonal
balance and most coherent imaging (the closer, the better). Any separation
greater than 60cm is likely to result in degraded sound quality. Try to alter
the pase of the tweeter if the sound that produced is not natural. For ease of
installation use original factory speaker location. Using these positions will
save considerable installation time and provide the best integration. Avoid
installing speaker behind thick stock fabric or cloth. This could especially
in the case of tweeters restrict output and reduce sound volume.
We suggest fi rst mounting each mid/woofer and attaching the cables. Then
you can determine the optimum tweeter location by auditioning the tweeter
at several positions in your car before permanent installation.
Woofer
6”
Woofer
6”
Midrange
3”
Tweeter
Tweeter