4.2 Set task/load task
Method 1: Load a saved task, select "Load Mission" in the UAV tab to load the
planned aerial survey mission.
Method 2: The mission can be planned on site, see the chapter "Aerial Survey
Mission Planning" for details. After the waypoint mission is generated, the mission
will be automatically uploaded to the aircraft autopilot.
Introduction to the task synchronization mechanism of the ground station
(advanced function):
The tasks between the ground station and the aircraft will be automatically
synchronized, and any operations on the ground station, including task changes,
will be immediately uploaded to the UAV, and executed immediately without
manual uploading.
⚫
Special condition 1: If the communication link is disconnected and the
synchronization fails, the ground station will restore the task to the state before
the change.
⚫
Special Condition 2: If the ground station restarts while the aircraft is
To Next Page
Loading...