Flykly Smart Ped - Bitride HMI for Smart Ped; Using the Dashboard; Locking and Unlocking Your Smart Ped; Dashboard Menu Options

26
27
The bitride dashboard for the Smart Ped displays the following information:
o Bike SPEED [Km/h] or [mi/h]
o Total ODO [Km] or [mi]
o Partial ODO [km] or [mi]
o Motor Power [W]
o State of charge of the battery [%]
o Warning icon (see 4.8)
4.2 Locking / Unlocking your Smart Ped (Figure 7)
Your Smart Ped features an electronic lock that can be enabled by swiping to
the right the lock icon .
This function makes the rear wheel of your bike stiffer and very difficult to
pedal on. This function is available when the battery charge is greater than
20% AND the bike is at 0 km/h. This function is unavailable while charging
your Smart Ped. Once the lock is activated this will work even if you disconnect
your smartphone from the bike. To unlock the bike, just connect your
smartphone, press and hold the lock icon.
!
NOTE: the embedded electronic lock will not prevent thieves from stealing
your bike. Please use an additional mechanic lock during prolonged stops.
!
NOTE: the embedded electronic lock drains a little energy from the battery.
You can check the remaining energy on the lock screen of your smartphone.
4.3 Dashboard menu (Figure 6)
In this screen you can customize the motor assistance while pedalling (see
also 4.6), the amount of regenerative brake (KERS) and the units you prefer
to display speed and distance. Furthermore, you can perform the factory
reset of your Smart Ped by sliding the factory reset icon on the right side
of your screen.
For any modification performed in this screen the bike must be still (speed
must be 0 km/h).
4.4 Performing a factory reset on the Smart Ped
In order to perform a factory reset on your Smart Ped, please tap the
hyperlink “factory reset” on the dashboard menu. The app will ask you to
insert the pin of your bike to perform the factory reset.
This procedure will reset the bike name, the bike PIN and the e-mail
associated with your Smart Ped.
4. bitride HMI for Smart Ped
Even if it is possible to use the Smart Ped with out the bitride app, you can
access more features if you connect it to a smartphone.
To access the “ride” screen tap the hamburger menu on the upper left
side of the screen and select RIDE. To access the online dashboard please
connect to your Smart Ped by following the instruction in 3.6.
4.1 Using the dashboard (see Figure 6)