Flykly Smart Ped - Smart Ped Maintenance; Electrical Component Maintenance

36
37
TIRES AND TUBES
o Clean the tyres and check treads weariness.
o Remove any debris from tread or walls.
o Check tire pressure.
o Replace faulty tubes.
WHEELS
o Clean rims and check if they are dented or dimpled.
o Check rims alignment and spokes tension.
o Replace any bent or broken spoke.
BRAKES
o Check brake pad and brake lever fitting bolts.
o Check brake pads weariness and replace them if necessary
o Check the brake pad toe-in alignment.
BRAKE CABLE AND CABLE GUIDE
o Inspect all cable housing. Replace if damaged.
o Clean and examine all cable (kinks and frayed ends). Replace if nec-
essary.
o Adjust barrel adjusters and/or cable anchor bolts to compensate ca-
ble stretch.
HUBS
o Check front and rear hub bearings to prevent excess play or binding.
Fit cup-and-come bearings, tighten or release if necessary.
o Check if hubs are correctly lubricated.
o Tighten hub axle nuts and check any clamp.
GENERAL CONTROL
o Check frame alignment and any eventual dent or damage on the tubes.
o Check that all bolts, nuts and clamp are correctly fixed.
2. Electrical components
!
CAUTION: Every maintenance procedure (even cleaning the Smart Ped)
must be done without activating your Smart Ped (see 2.1) On the contrary,
severe injury may occur.
2.1 Cleaning the electrical component
The Smart Wheel
Please, keep the Smart Wheel clean. Clean it with a soft, damp cloth. The
Smart Wheel may not be immersed in water or cleaned with high pressure
cleaner. DO NOT use a high pressure water jet to clean The Smart Wheel.
For service, firmware upgrades, battery substitutions and repairs on the
hub, pleas refer to authorized Flykly dealers.
2.2 After-sales Service and Customer Care
In case of questions concerning your Smart Ped or one of its components
please read the FAQ on the Flykly website (www.flykly.it). In case you do
not find an answer, please or sending an e-mail to hello@flykly.com .