38
39
When contacting Flykly for an issue related to your Smart Ped please
provide one of the following information together with the problem
description:
o Registration e-mail for your Smart Ped
o Bike name
o Bike MAC address (it can be found in the bluetooth option on your
smartphone)
2.3 Transport
Item with internal battery packs are subject to Dangerous Goods Legisla-
tion requirements. Private users can transport such undamaged items by
road without further requirements.
When being transported by commercial users or third parties (e.g. air
transport or FWD agencies), special requirements on packaging and label-
ing must be observed (e.g. ADR regulations). If necessary, an expert for
hazardous materials can be consulted when preparing the item for ship-
ping.
Dispatch your Smart Ped only when the housing is undamaged.
Tape or mask off the 6-pin connector in such a manner that the connector
itself cannot be damaged or broken. Inform your parcel service that the
package contains dangerous goods. Please also observe the possibility of
more detailed national regulations.
In case of questions concerning transport of the Smart Ped, please refer to
an authorized Flykly dealer.
Smart Ped dealers can also provide suitable transport packaging.
3. Notes on the battery pack
The battery pack is protected against deep discharging, overcharging,
overheating and short circuit through the Battery Management System
(BMS). In case of dangerous situation an electronic protection will switch
the battery pack off.
Although the battery pack is protected from deep discharging, it is recom-
mended to fully charge the battery pack before the first use of the bike.
3.1 Charging your Smart Ped battery pack (see also 2.4)
The battery pack can be recharged at any time without shortening its lifes-
pan. Interrupting the charging process does not damage the battery pack.
!
CAUTION: DO NOT charge a damaged Smart Ped. Please refer to an autho-
rized Flykly dealer.
In order to recharge your Smart Ped connect the charger plug to the
charging connector located on the right side of the Smart Ped axle. Then
connect the charger plug to an outlet (see 2.4, Figure 5).
!
CAUTION: check the mains voltage: it must match the one indicated below
the charger itself!
The charging procedure will start as soon as the charger is connected both
to your Smart Ped and to the mains. While charging, the LED located on
the charger is red.
To Next Page
Loading...
