14
15
Brake pad-to-rim clearance can be adjusted changing the brake cable
length at the brake arm or through the brake lever cable adjuster.
The brake pads should be adjusted in order to be parallel to the rim
flank and keep about 1-2 mm clearance with the flank. Ask your Flykly
dealer how to reach the correct adjustment.
!
CAUTION: Be sure that cable stopper and cable guide are correctly po-
sitioned when you repair of fit your brake system.
!
CAUTION: contact your dealer to fit your brakes in case of any doubt.
5. FOLDING YOUR SMART PED
!
If you have a Folding Smart Ped NEVER ride without the Block Pin (19):
5.1 Folding the board 7a - 7b
This part applies to the folding model
In order to fold the board in half, please lift gently the joint with your foot
and extract the block pin. The axle play of the joint is necessary to perform
the folding movement. Even if you can feel a play, the joint has been
designed and tested to support up to 120 kgs.
Lean the smart ped towards you while holding the handlebar. Then lift
gently the front wheel and fold the board in half.
Secure the 2 parts of the board (7a) and (7b) with the velcro stripe (19).