EN
01 02 03 04 05 06 07 08 09 10 11 12 13 14
15 16 17 18 19 20 21 22 23
24 25 26 27 28 29 30 31 32
33 34 35 36 37 38 39 40 41 42
43 44 45 46 47 48 49 50
51 52 53 54 55 56 57
In any of the following situations, the smart clamp turns protection on.
LED Indicator
The red/green led will flash
The green light is always on
The red light is always on with
long audio alarm
The red light flashes with short
audio alarm
The red light is always on with
long audio alarm
The red light is always on with
short audio alarm
The voltage of the jump starter is too low.
-Try to replace the jump starter or charge it in time.
Situations
Ready to work
Work status
1.Battery clamp is reversely connected.
-Check whether the clamp is reversely connected.
2.The clamp is short-circuited.
-Check whether two clamps together connect or connect both clamps to the
same piece of metal.
Reverse charging protection, the voltage of the car battery is higher than 12.6V.
-No jump starter needed, the car battery is enough to start your car.
The temperature of the clamp exceeds 65(+/-5) degrees.
-Remove the clamp until the red/green light flash
To Next Page
Loading...
