Flymo GardenVAC - Using Your Gardenvac; Blow Mode Operation; Vacuum Mode Operation; Jet Vacuum Mode Operation

8
USE
How to Use
N - BLOW
Using As A Blower
1. Select position 1 on the mode indicator (A3). See fig N.
2. Point nozzle (A7) towards the ground.
3. To start squeeze trigger (A1).
4. Stand back from debris to be cleared.
5. Point nozzle (A7) towards the debris and slowly approach.
6. To stop release trigger (A1).
Position 1 - Blow Mode
The Gardenvac will blow debris from patios, paths,
driveways, lawns, bushes, borders etc.
O - VACUUM
Using As A Vacuum
1. Select position 2 on the mode indicator (A3). See fig O.
2. Position nozzle (A7) slightly above the debris, squeeze the trigger
(A1), and move slowly back and forth.
3. Do not force the nozzle (A7) into the debris as this will impair
performance.
4. To stop release the trigger (A1).
Position 2 - Vacuum Mode
In this position your Gardenvac will pick up leaves, paper,
rubbish, cans etc.
P - JET VACUUM
Using As A Jet Vacuum
1. Select position 3 on the mode indicator (A3). See fig P.
2. Position the nozzle (A7) above and slightly forward of the debris
and squeeze the trigger (A1).
3. Slowly move the nozzle (A7) back over the debris. This allows a
jet of air to lift the debris from the ground.
4. To stop release the trigger (A1).
Position 3 - Jet Vacuum Mode
This position is intended to be used to collect debris
which is damp or stubborn. It directs a small jet of air
towards the ground which will loosen stubborn material.
WARNING
The use of eye protection is recommended. The use of ear protection is recommended.
To prevent dust irritation, the wearing of a face-mask is recommended. Never point your
Gardenvac at bystanders. Do not use your Gardenvac in the rain. Do not leave your Gardenvac
outdoors while it is raining.
IMPORT
ANT!: YOUR GARDENVAC WILL
NOT OPERATE UNTIL THE FULLY ASSEMBLED DEBRIS
BAG AND FRAME ARE PROPERLY FITTED.
BEFORE USE: E NSURE THERE ARE NO GAPS BETWEEN THE DEBRIS BAG AND THE PRODUCT .
• The Gardenvac has 3 modes of operation.
• These can be selected by moving the mode indicator to adjust the nozzle position for blow, vacuum
or jet vacuum mode.