4
To Start your Lawnmower
1. Form loop in mains cable and push the loop
through the slot as illustrated in picture (C)
2. To secure, position loop over the hook and pull
the cable back through the slot as illustrated in
picture (D).
3. Connect plug to mains.
4. Move handle to the mowing position. See Fig.
E.
5. To prevent a ring being cut in your lawn, tilt your
lawnmower slightly (E).
• The switchbox is provided with a lock-off
button (F1) to prevent accidental starting.
6. Press and hold the lock-off button (F) on the
switchbox, then squeeze one of the Start/Stop
levers towards the upper handle (G).
7. Continue to squeeze the start/stop lever towards
the upper handle and release the lock-off but-
ton. (H)
8. When the lawnmower has reached full speed
gently lower it onto the lawn.
• NOTE
There are two start/stop levers fitted. Either
one can be used for starting the lawnmower.
• IMPORTANT
Do not use the start/stop levers intermittent-
ly
To Stop your Lawnmower
1. To prevent a ring being cut in your lawn, tilt your
lawnmower slightly (E).
2. Release the pressure on the Start/Stop lever.
Starting and Stopping
C D
E F
G
1
How to Mow
1. Start mowing the edge of the lawn nearest to
the power point so that the cable is laid out on
the lawn you have already cut. (J)
2. Mow twice a week in the growing season, your
lawn will suffer if more than one third of its
length is cut at one time.
Do not Overload your Lawnmower
Mowing long thick grass may cause the motor
speed to drop, you will hear a change in the
motor sound. If the motor speed drops you may
overload your lawnmower which may cause
damage. When mowing in long thick grass, a
first cut with the cutting height set higher will
help reduce the load. See Adjusting the Cutting
Height.
H
J
To Next Page
Loading...
Need help?
General
