Grassbox
L
• For optimum performance your product is designed
to be used with the grassbox fitted.
Emptying the Grassbox (L)
• Stop the product and wait until the cutting head has
stopped rotating before emptying the grassbox.
1. Remove the grassbox lid.
2. Lift the grassbox off the product and empty.
3. Replace grassbox and lid carefully.
• Failure to fit the grassbox and lid correctly will
cause poor collection of grass clippings.
Cutting System Maintenance
• Always handle the plastic cutters with care - sharp
edges could cause injury. USE GLOVES.
Checking your Cutting System (M)
• The cutting system must be kept in good condition
and inspected before and after use.
• Disconnect from the mains electricity supply and
wait until the cutting head has stopped rotating. Turn
your product upside down.
1. Visually check cutting head for wear. Replace if damaged.
2. Visually check plastic cutters for wear and replace
when necessary.
3. Plastic cutters should be straight. Replace if bent or twisted.
Replacing Plastic cutters (N)
• Use only genuine Flymo replacement plastic cutters
specified for this product. These are available from
all Husqvarna UK Ltd. Service Centres and major
retail outlets.
• Plastic cutters must be replaced in pairs to retain balance.
• Two plastic cutters of the same type should be fitted.
• Never fit a steel bar blade to this product.
To Re place Plastic Cutters
• Disconnect from the mains electricity supply and
wait until the cutting head has stopped rotating. Turn
your product upside down.
1. Push plastic cutter towards centre of cutting disc.
Lift plastic cutter away from cutting head. (P)
2. If the plastic cutter is broken during use - lever cutter
out of the slot, and dispose of carefully.
3. Fit new plastic cutters into the slots at each side of
the cutting head and pull into place. (Q)
• IMPORTANT ENSURE PLASTIC CUTTERS ARE
CORRECTLY LOCAT
ED.
M
N
QP
cutting
head
plastic
cutters
hood
fan
To Next Page
