Flymo SimpliMow 300 - Technical Data; Troubleshooting; Service; Warranty

Problem Possible Cause Remedy
Engine is jammed and
makes a noise
Motor is blocked. v Remove the obstacle.
Start again.
Cutting height is too low. v Raise the cutting height.
Loud noises, the mower
is rattling
Screws on engine, its fixing
or on the mower chasing are
loose.
v Let the screws be tightened
by an authorised specialist
dealer or the FLYMO Service.
Mower runs unevenly or
vibrates strongly
Blade is damaged / worn or the
blade mounting is released.
v Replace the blade.
Blade is very dirty. v Clean the blade.
Lawn is not cleanly mowed Blade is blunt or damaged. v Replace the blade.
Cutting height is too low. v Raise the cutting height.
For any other malfunctions please contact the Husqvarna UK Ltd. Customer
Service. Repairs must only be done by Husqvarna UK Ltd. service departments
or specialist dealers approved by FLYMO.
7. TECHNICAL DATA
Electric Lawnmower Unit Value
SimpliMow 300
9679906-xx
Rated power W 1000
Mains voltage V (AC) 230
Mains frequency Hz 50
Speed of rotation cutting
blade
R/min 3600
Cutting width cm 30
Cutting height adjustment mm
20 – 60
(3 positions)
Volume of grass box l 30
Weight kg 8.2
Sound pressure level L
pA
1)
Uncertainty k
pA
dB (A)
88.4
3
Sound power level L
WA
2)
:
measured / guaranteed
Uncertainty k
WA
dB (A)
91 / 92
1
Hand / arm vibration a
vhw
1)
Uncertainty k
vhw
m/s
2
3.7
1.5
Measuring process complying with:
1)
EN 60335-2-77
2)
RL 2000/14/EC / S.I. 2001 No.1701
NOTE: The stated vibration emission value has been measured according to
astandardized test procedure and can be used for comparison of one electric
power tool with another. It can also be used for preliminary evaluation of expo-
sure. The vibration emission value can vary during actual use of the electric power tool.
8. ACCESSORIES
FLYMO Replacement Blade
for SimpliMow 300
As replacement for blunt blade. Art. FLY 085
9. SERVICE / WARRANTY
Service:
Please contact the address on the back page.
Warranty statement:
In the event of a warranty claim, no charge is levied to you for the
services provided.
Husqvarna UK Ltd. grants a warranty for all original FLYMO new products
for two years from the date of original purchasefrom the retailer, provided
that the devices have been for private use only. This manufacturer’s war-
ranty does not apply to products acquired second hand. This warranty
includes all significant defects of the product that can be proved to be
material or manufacturing faults. This war ranty is fulfilled by supplying
afully functional replacement productor by repairing the faulty product
sent to us free of charge; we reserve the right to choose between these
options. This service is subject to the following provisions:
• The product has been used for its intended purpose as per the
recommendations in the operating instructions.
The airflow slots must always be clean.
To clean the underside of the mower:
The underside is easiest to clean after you mowed.
1. Lay the mower on its side carefully.
2. Clean the underside, the blade and the discharge opening with
a brush (do not use sharp objects).
To clean the overside of the mower and the grass box:
1. Clean the overside with a damp cloth.
2. Clean the airflow slots and the grass box with a soft brush
(do not use sharp objects).
5. STORAGE
To put into storage:
The product must be stored away from children.
1. Disconnect the mower from the mains.
2. Clean the mower (see 4. MAINTENANCE).
3. Store the mower in a dry, enclosed and frost-free place.
Disposal:
(in accordance with RL2012/19/EC / S.I. 2013 No. 3113)
The product must not be disposed of to normal household
waste. It must be disposed of in line with local environmental
regulations.
IMPORTANT!
v Dispose of the product through or via your municipal recycling collection
centre.
6. TROUBLESHOOTING
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Wait for the blade to stop, disconnect the product from the
mains and use gloves before you troubleshoot the product.
To replace the blade [ Fig. T1 / T2 ]:
DANGER! Risk of injury!
Cut injury when the blade turns and it is damaged,
bent, out of balance or has chipped edges.
v Do not use the mower when the blade is damaged, bent,
out of balance or has chipped edges.
v Do not regrind the blade.
The FLYMO spare parts are available from your FLYMO dealer or from
the FLYMO service.
Only use an original FLYMO blade:
• FLYMO replacement blade for SimpliMow 300: Art. FLY 085
1. Ensure the lawnmower is stopped and disconnected. Insert a screw-
driver through the reinforced hole on the deck into the drive pulley
wheel to stop the wheel from turning.
2. Unscrew the blade bolt. Take care not to damage the drive pulley wheel
when applying force.
3. Remove the blade bolt and the washer.
4. Remove the blade.
5. Put the new blade on the lawnmower.
6. Put the washer and the blade bolt on the lawnmower.
7. Screw the new blade tight with the blade bolt. Tightening torque is
15 – 20 Nm. Do not over- torque. Take care not to damage the drive
pulley wheel when applying force.
8. Ensure the screwdriver is removed before attempting to turn on the
machine.
Problem Possible Cause Remedy
Mower does not start Mains cable is disconnected
or damaged.
v Connect the mains cable or
if necessary let it be replaced
by an authorised specialist
dealer or the FLYMO Service.
Motor is blocked. v Remove the obstacle.
Start again.
6
21300-85.960.02.indd 621300-85.960.02.indd 6 05.10.21 14:0605.10.21 14:06