Flyron Technology Co., Ltd. FN-T718 Industrial MP3 Player
www.flyrontech.com E-mail: info@flyrontech.com
Note: If there is no config file on the built-in flash memory/micro SD card/USB flash drive, the device will
always works with the mode “0” by default.
2. How to create a config file
Users can create a config file without or with volume setting. The volume knob on the device controls the
speaker outputs only, so if some users want to adjust volume from the 3.5mm audio jack output, it’s
necessary to create a config file with volume setting, otherwise a config file without volume setting is
enough. By the way, in the same time the speaker outputs is also subject to the volume setting in the
config file.
2.1. Create a config file without volume setting
1). Firstly create a new text file on computer (desktop or somewhere else).
Corresponding Trigger Mode
Short press the button to start playing, and during playing, if you press the button again, the
playback will be interruptible and it will play from the beginning.
Press the button and hold to start playing repeatedly, and when the button is released the
board stops playing.
Short press the button to start playing, and during playing, if you press the button again, the
playback will be NOT interruptible.
In this mode, K1 works as Next, K2 Previous, K3 Play/Pause, K4 Stop, K5 Volume Up, K6
Volume Down, K7 Random playback (it plays a sound randomly after each triggering).
Special function: When K1 is short-circuited to GND first and use this mode in the config file
and once power is applied, the board is able to play a sound in a loop or play multiple
sounds one by one in a loop until power is off.
In this mode, sound file 000.mp3 will play in a loop when power is applied. Any button from
K1 to K7 (associated 001.mp3 to 007.mp3) can interrupt it and switch to play the associated
sound file. Once the associated sound file finishes the playback, sound file 000.mp3 will
continue to play in a loop.
Each button from K1 to K7 have their associated folders from 01 to 07 respectively. Each
folder can store multiple files (for example from 001.mp3 to 030.mp3). Short press the
button to play sound file 001.mp3, and short press again to play the next file 002.mp3, and
so on. When the last sound file finish playing, short press again to go back to playing file
001.mp3. During playing, if you press the button again, the playback will be interruptible and
it will play next file.
The same as mode “5”, but during playing, the playback will be uninterruptible.
Each button from K1 to K7 have their associated folders from 01 to 07 respectively. Each
folder can store multiple files (for example from 001.mp3 to 030.mp3). Short press the
button to play all of the sound files in order one by one. During playing, if you press the
button again, the playback will be interruptible and it will play next file and continue to play
the rest of the file. When the last sound file finishes playback, it’ll stop.
To Next Page
Loading...