Flyron Technology Co., Ltd. FN-T718 Industrial MP3 Player
www.flyrontech.com E-mail: info@flyrontech.com
3). Save it and close it.
4). Rename the file “Config” or any other name you like.
3. Audio Files Loading/Updating
Users can use a micro USB data cable to connect the board to computer. The built-in flash memory will be detected
as a USB flash drive on computer. If the built-in flash memory is not large enough to store your audio file, you can
use a micro SD card or USB flash drive instead. When there is an inserted micro SD card, there will be two
simulated USB flash drives on computer (one is the built-in flash memory and the other one is the micro SD card), so
please note to recognize.
3.1. For Trigger Mode 0-3
To these four modes, the audio files need to be placed on the root directory of the storage device (built-in flash
memory or micro SD card). The arrangements of the audio files are managed by a physical index order. In other
words, the file that is to be loaded first in the storage device will be associated with input “K1”. The last file to be
loaded in the storage device will be associated with input “K7”. In order to guarantee a correct ‘one-on-one’ order,
please refer to the following steps.
1). Build a new folder on the computer and put the 7 audio files in this new folder.
2). Rename the audio files from 001.mp3 to “007.mp3”, and make sure they are ranked from “001.mp3 to
“007.mp3” in order.
3). Connect the device to computer through a USB data cable.
4). Delete the pre-loaded audio files for tested purpose at factory, or empty the micro SD card if it has other
files inside.
5). Go back to the folder and select all of the 7 audio files in the folder.
6). Right click on the first file (001.mp3) and choose "Send to removable disk" or “Send to USB flash drive”.
7). This will send the 7 audio files to the on-board flash memory or micro SD card one by one in a correct
sequence.
8). Move the prepared config file with the trigger mode needed onto the root directory together with the audio
files as below then refresh.
To Next Page
Loading...