Need help?Do you have a question about the FlySky FS-CT6 (A/B) and is the answer not in the manual?
General| Channels | 6 |
|---|---|
| 2.4G System | AFHDS |
| Modulation | GFSK |
| Sensitivity | 1024 |
| DSC Port | Yes |
| Antenna Length | 26mm |
| Model Type | Helicopter, Glider |
| RF Range | 2.4GHz |
| RF Power | Less than 20dBm |
| Low Voltage Warning | Yes |
| Band | 2.4GHz |
Covers unpacking contents, installing drivers, and assigning a COM port for the USB cable.
Guides the user on selecting the correct COM port within the T6config software.
Explains how to save the default radio settings using the T6config software.
Details how to select the transmitter mode (e.g., Mode 1, Mode 2) for the model.
Guides loading saved configurations and selecting the aircraft type in T6config.
Details the functions and assignments of switches, knobs, and buttons on the transmitter.
Explains the purpose and operation of the Bind/Range Test button.
Covers how to program custom mixes for advanced control functions.
Describes how to adjust the end points for individual servo channels.
Explains how to reverse the direction of servo operation for each channel.
Details how to adjust subtrim for fine-tuning model centering and trim tab use.
Guides programming dual rates for varying control surface throws.
Notes that the 'Help' button in the software is not functional.
Configuration for setting up 2 servo ailerons using mixes.
Configuration for implementing flaps using control mixes and switches.
Setup for Delta or Elevon wing configurations using mixes.
Describes mixes for V-tail aircraft, with or without ailerons.
Configuration for Flapperon or Spoileron control surfaces.
Setup for controlling gyro gain using mixes and transmitter controls.
Step-by-step instructions for binding the receiver (Rx) to the transmitter (Tx).
Discusses FCC certification differences between T6A and T6B models.
Information on battery types, charging, and port specifications.
Mentions an alternative software called Digital Radio for configuration.
Describes the programming port and simulator cable options.
Explains the incompatibility between T6A and T6B receivers and transmitters.
To Next Page
