Need help?Do you have a question about the FM HARBIL 24018 and is the answer not in the manual?
Provides information on warning labels affixed to the mixer and within the manual.
Explains the types of safety notices, Warning and Caution, used in this manual.
Instructions for connecting the mixer to a power source, including wire gauge recommendations.
Guidelines for using extension cords with the paint mixer, specifying requirements for safe use.
Steps to check and realign the mixer's internal struts for proper operation.
Instructions for leveling the mixer using its adjustable feet to ensure stability.
Identifies key components of the mixer, such as the control panel and safety switches.
Details the buttons and functions available on the mixer's control panel.
Explains the procedure for reversing the mixer's front door for different spatial layouts.
Lists critical safety warnings, including operational hazards and flammability concerns.
Lists important precautions for safe operation, container handling, and material mixing.
Illustrates the correct placement of support discs for 5-gallon containers during operation.
Details lubrication tasks to be performed on specific parts of the mixer weekly.
Outlines lubrication tasks for the Super-Struts, to be performed every three months.
General notes and additional information relevant to troubleshooting mixer issues.
Advice on disassembling the mixer, replacing parts, and contacting customer service.
Outlines essential safety precautions that must be followed before performing any servicing.
Step-by-step instructions for removing the outer sheet metal coverings of the mixer.
Instructions for safely removing the counterweights from the mixer's shake frame.
Steps for replacing or adjusting the DC clamping motor for proper function.
Procedure to adjust the clamping force using a gauge and spacer for optimal performance.
Steps to remove the mixer's exterior panels to access internal components.
Procedure for carefully removing the existing struts from one side of the mixer.
Detailed steps for installing new super-struts, ensuring correct alignment and tension.
Steps required to gain access to the mixer's crankshaft assembly.
Procedure for removing and discarding the old crankshaft assembly.
Steps for installing the new crankshaft assembly, including alignment and securing.
This section assists in performing service functions related to mixer parts.
This section assists in identifying various parts of the mixer.
To Next Page
General