6
PRODUCT INTRODUCTION
EN
Features
Because of the sturdy driving style, not playing cards according to common sense, and being
familiar with the local climate and terrain, he has repeatedly won by surprise. Soon, the name of
“Butcher Butch”spread.
To be continued...
FCX24 is positioned as a high-performance crawler chassis. The carframe is made of
high-strength nylon. Compared with the trapezoidal beam spliced by metal side beams and plastic
trusses, the overall weight is lighter and the strength is higher. The mid-mounted power assembly
has a low center of gravity and integrates the 2-speed transmission, transfer case and 130 motor.
The power is transmitted to the front and rear axles through the universal joint drive shaft. The
axles are equipped with wheel side reducers, commonly known as "portal axle", which can
increase the ground clearance of the differential tooth pack and improve the passability.
The crawlersare generally equipped with front and rear straight axles to simulate the locked state
of the real car differential to improve off-road passing ability. The FCX24 is equipped with a
straight axle by default, but the planetary gear differential can also be replaced with high-viscosity
silicone oil to simulate the driving effect of an LSD limited-slip differential. After installing the
differential, the ultimate climbing ability will be reduced, but a smaller turning radius and a more
stable high-speed driving quality can be obtained. Simply put, the straight axle is suitable for
extreme climbing, and the limited-slip differential is suitable for high-speed off-road. The choice is
yours.
The two-speed gearbox uses the CH3 of the remote control and is operated by a 9G steering gear.
The low gear reduction ratio is 99, which is larger than that of similar products currently on the
market. The torque output is strong, and easy for extreme climbing. The high gear reduction ratio
is 24.75, and the speed is higher than that of all similar products currently on the market. You can
experience the fun of high-speed breakthrough, small jump, and even heading up.
Stainless steel ball bearings are always the favorite of players, but in order to reduce the street
price, most brands will choose bushings as a replacement for all or part of the bearings. However,
considering that players need to completely disassemble the whole car to upgrade the bearings in
future, which is slow and laborious, FCX24 chooses to pre-install the whole car with a total of 24
bearings, which does not need to be disassembled and re-upgraded, saving time and effort, and
addresses the concern once for all.
● Ready to run model
● Two speed transmission
● Portal axle
● 24 ball bearings full set
● Metal gears steering servo
● Four link suspension
● High strength integrated nylon frame
● Power wagon polystyrene body
● Rapid separation car body
● Nylon roll cage
● Painted body
● Remote control lighting system
● Original personalized stickers
About Model
To Next Page
Loading...
