EN
3
Transmitter Battery Installation
Battery Type: AAA
Battery Installation:
1. Open the battery compartment cover.
2. Insert 4 fully-charged AAA batteries into the compartment. Make sure that the
battery makes good contact with the battery compartment's contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2V, the LED on the
panel will flash slowly.
Note: When installing the batteries, be careful to handle the positive and
negative poles. (As shown in the picture on the right)
Reversing
light
Emergency
Flashers
Position
OFFOFF OFF OFF
OFFOFF OFF
•
Control
Mod
Remarks
The reversing lamp is
on during reversing
operation
Throttle linkage
control
LED2#
Turn
Signal
Left turn
signal
Left turn
signal
Emergency
Flashers
OFF
Direction
linkage
controL
Direction
linkage
controL
OFF
OFF
OFF
I II
Times for Pressing
Button
Light
LED
1#
Headlight
Rear light
•
• • • • •
• •
Function
Power on is
off by default
I II III IV V
To Next Page
Loading...
