Why are the controls reversed on my FMS Kingfisher 1400mm?
If your FMS Toy aircraft's controls are reversed, it's likely that the channels are reversed in the transmitter. Perform a Control Direction Test and adjust the controls for both the aircraft and the transmitter.
What to do if my FMS Kingfisher 1400mm Toy aircraft throttle is not responding?
If your FMS Toy aircraft isn't responding to the throttle but responds to other controls, it could be due to a few reasons. First, the ESC might not be armed; try lowering the throttle stick and throttle trim to the lowest settings. Alternatively, the throttle channel might be reversed. In that case, reverse the throttle channel on the transmitter.
Why does the motor on my FMS Toy lose power?
If your FMS Toy aircraft's motor loses power, there might be damage to the motor or battery. Inspect the batteries, transmitter, receiver, ESC, motor, and wiring for any damage, and replace components as needed.
Why is my FMS Kingfisher 1400mm flight time so short?
If you're experiencing reduced flight time or the FMS Toy aircraft feels underpowered, it could be due to several reasons. The flight battery charge might be low, so completely recharge it. Alternatively, the flight battery could be damaged, so replace it and follow the battery instructions. Also, there might be a loss of power to the aircraft. If this is the case, land the aircraft immediately and recharge the flight battery.
How to fix extra propeller noise on FMS Toy?
If you notice extra propeller noise or vibration in your FMS Toy, it could be due to a few reasons. Check for damage to the spinner, propeller, motor, or motor mount and replace any damaged parts. Also, ensure that the propeller and spinner parts are not loose; tighten the parts for the propeller adapter, propeller, and spinner. Finally, make sure the propeller isn't installed backwards; remove and install it correctly if needed.
What to do if FMS Toy motor pulses then loses power?
If the motor power pulses and then loses power on your FMS Toy, it's possible the ESC is using the default soft Low Voltage Cutoff (LVC). Check the connection from the ESC to the receiver.
Why is the control surface on my FMS Toy not responding?
If a control surface on your FMS Toy does not move or responds slowly to control inputs, it could be due to damage to the control surface, control horn, linkage, or servo. Replace or repair any damaged parts and adjust the controls. Also, check the wiring for any damage or loose connections.
General safety rules for operating the RC model, including age recommendations and operational environment.
Cautionary advice on handling, charging, and storing Lithium Polymer batteries to prevent hazards.
Specific instructions for safely charging Li-Po flight batteries using compatible chargers.
Instructions for correctly installing the flight battery for proper weight distribution.
Key details about the ESC, motor, and battery for safe and correct operation.
Essential pre-flight procedure to ensure radio control system integrity and range.
General| Wingspan | 1400mm |
|---|---|
| ESC | 40A |
| Radio | 4 Channel |
| Material | EPO Foam |
| Servos | 9g x 4 |
| Battery | 11.1V 2200mAh LiPo |
To Next Page