Need help?Do you have a question about the Fnirsi 1013D and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Bandwidth | 100 MHz |
| Sample Rate | 1GSa/s |
| Input Impedance | 1 MΩ |
| Connectivity | USB |
| Test Voltage Range | 400 V (DC + AC Peak) |
| Probe Attenuation | 1x, 10x |
| FFT | Yes |
| Roll | Yes |
| Display | 7 inch LCD |
| Time Base Range | 5ns/div to 50s/div |
| Trigger Modes | Edge, Pulse, Video, Slope |
| Vertical Resolution | 8 bit |
| Coupling | DC, AC, GND |
| Waveform Capture Rate | 10, 000 wfms/s |
| Vertical Sensitivity | 50mV/div ~ 500V/div |
Important reminder regarding the correct usage of 1X and 10X probes for accurate measurements and to prevent signal attenuation.
Details on primary interface elements like menu, run/stop, and auto-set buttons.
Solutions for common issues like no waveform, incorrect voltage/frequency data, and unstable signals.
Guidance on capturing pulse waveforms, DC signals, and understanding signal behavior.
Addresses issues like waveform shaking, charging problems, and voltage measurement discrepancies.
Procedure for measuring battery and DC voltages using the oscilloscope with appropriate gear selection.
To Next Page
