WARNING
Do not open the amplifier or undertake any modifications to the product. There is a risk of accident, fire
or electric shock.
Tin the end of the power supply cable before you connect it to the battery’s positive (+) terminal. Weld the
end of the cable to the terminal lug that is going to be used for the battery’s positive (+) terminal. Connect the
terminal lug to the battery’s positive terminal.
Insert the fuse into the fuse-holder, and screw in tightly.
The connection phase has now been completed. Now all you need to do is to check that you have the right
power supply and verify that the overall set-up – car radio + amplifier + loudspeakers – works properly. Set all
gains (both source gains and amplifier gains) to their minimum levels. Switch on the various parts of the system.
Once you have switched on all of the parts, test the system at low sound level.
fig. 13
40 cm max
10
fig. 14
ACCESS SOLUTION 25 A1
User Manual
notice solution 25 a1.indd 10notice solution 25 a1.indd 10 13/02/07 17:40:0813/02/07 17:40:08
To Next Page
Loading...
