• Connection
Before connecting to the mains supply please check that the voltage selector switch and fuse
value is correctly set to correspond with your supply voltage.
A - Hi-fi configuration:
Connection using the low-level
inputs (“PRE OUT” outputs
from the preamplifier).
Connection using the high-level inputs
(loudspeakers output from the amplifier).
In the case of high-level connection, Cub should be connected to the amplifier using a high
quality pure copper cable of at least 1.5mm. Connect the “+” from the amplifier to the “+”
on the Cub (red) and the “-” from the amplifier to the “-” of the Cub (black).
8
User manual
To Next Page