19
FDS AMPLIFIERS
User manual
WARNING
• Do not operate any functions which may distract you while driving. Functions requiring sustained
attention must only be used when the vehicle is at a complete standstill. Always make sure to stop
your vehicle in a safe place before operating these functions. Failure to do so may cause an accident.
• Keep the volume at a low level to be able to hear exterior noises while driving the vehicle. Failure
to do so may cause an accident.
• Do not open your FDS amplifier or make any modifications to the product. Failure to do so may
cause an accident, a fire or an electric shock.
• Only use your FDS amplifier with 12V mobile applications. Any use other than the intended use may
cause a fire, an electric shock or injury.
• Use fuses with the adequate amperage. Failure to do so may cause a fire or an electric shock.
• Do not obstruct the heat sink on your FDS amplifier. Internal overheating may occur and cause a fire.
• Wire the connections correctly. Make sure you use the appropriate wire gauge and type of cable.
Failure to do so may cause a fire, injury and/or material damage.
• Do not use nuts or bolts on steering or breaking systems, tanks, seat-belt anchor points or other
safety elements for connecting the ground. Using of these parts as ground may deactivate the
vehicle’s control system and cause a fire or other damage.
• Keep small parts which could be swallowed, such as bolts, accessories or screws out of the reach of
children. Swallowing such parts may cause to serious injury. If swallowed, consult a physician.
• Before beginning installation, disconnect the negative terminal of the battery to avoid any risk of
injury, fire or material damage. (fig. 1)
fig. 1
To Next Page
Loading...
Need help?
General
