5.4 - Unplug the power cable, the ground cable and the remote cable from the amplifier.
5.5 - Wait 30 seconds and then unplug the HIGH-CAP(s).
5.6 - Plug the power cable, the ground cable and the remote cable to the amplifier through the adapted
terminals.
5.7 - Plug the negative cable of the battery.
CAUTION: A small electric arc may occur.
5.8 - Insert the fuse into the fuse-holder(s), and screw in tightly.
5.9 - Turn on the different elements. Once all the elements are on, carry out a test at low volume.
To Next Page
Loading...
