Need help?Do you have a question about the Focal IMPULSE 4.320 and is the answer not in the manual?
General| Type | Class D |
|---|---|
| Total Harmonic Distortion | <0.05% |
| Crossover | Yes |
| HP Crossover Frequency | 50Hz - 500Hz |
| LP Crossover Frequency | 50Hz - 500Hz |
| Frequency Response | 10Hz - 20kHz |
| Signal-to-Noise Ratio | >80dB |
| Input Sensitivity | 0.2V - 5V |
| Power Output 4 Ohms | 4 x 55 Watts RMS |
Details connecting amplifier wiring harnesses and cables.
Advises on preventing battery drain during extended use without the engine running.
Stresses the importance of not covering the amplifier to prevent overheating.
Recommends a well-ventilated area for correct operation and heat dissipation.
Provides instructions for positioning and securing the amplifier using its mounting bracket.
Highlights safe wiring practices and suggests professional help if uncertain.
Guides on choosing the correct wire gauge for power cables based on length.
Explains how to route RCA, speaker, and remote cables to avoid interference.
Details the essential safety step of fusing the positive (+) battery cable.
Outlines checks for power, connections, and initial low-volume testing.
Explains input types (RCA, high-level) and adjusting gain for optimal sound.
Describes the function of +12V, GND, and REM connectors for amplifier operation.
Details the POWER/PROTECT LEDs and the switch for selecting input signal type.
Guides on diagnosing problems using LED indicators and potential causes.
Covers INPUT SELECT, PHASE, X-OVER, and FRONT CH. filter functions.
Lists key technical specs like power output, bandwidth, and harmonic distortion.
Outlines the warranty terms and conditions for Focal products.
Lists the components included in the Y ISO Adaptation Cable accessory.
Alerts users to disconnect the battery before installing the accessory.
Requests user's name, address, and contact details for guarantee validation.
Asks about reasons for purchase and details of the Focal product acquired.
To Next Page
