Focal Solid - Technical Specifications; Performance Data; Features and Dimensions

SOLID AMPLIFIER
User manual
Solid 1 Solid 2
Solid 4
Nominal power measured at 14.4V
1 x 300W
2 x 75W
4 x 75W
continuously under 4 Ohms
THO + N ~ 1%
Signal/
Noise ratio
> 85dB (A)
> 77dB (A)
> 80dB (A)
(1 Watt Output) A- weighted filter
Nominal power measured at 14.4V
1 x 470W 2 x lOOW
4 x lOOW
continuously under 2 Ohms
THO + N ~ 1%
Power in bridged mode measured at
1 x 200W
2 x 200W
14.4V continuously under 4 Ohms
THD+N~l%
Nominal power measured at 14.4V
1 x 600W
continuously under 1 Ohm
(SPL mode/5min only)
THD+N~l%
THO + N @ 4 Ohms
0,01%@50Hz
0,02%@ 1kHz
0,02%@ 1kHz
Signal/Noise ratio (RMS) "" 100dB (A) "" 95dB (A)
"" 100dB (A)
Damping factor at 4 Ohms
50 to 50Hz
100 to 1 kHz 50 to 1 kHz
Frequency response
10Hz- 150Hz 10Hz - 60kHz
10Hz - 60kHz
Input impedance
20kil
20kil
20kil
Input sensitivity
0.2 - 5V 0.2 - 5V
0.2 - 5V
High-pass filter
50 - 150Hz (12dB/oet.)
50 - 150Hz (12dB/oet.)
Low-pass filter
50 - 150Hz (12dB/oct.) 50 - 150Hz (12dB/oct.)
50 - 150Hz (12dB/oct.)
SUBSONIC filter
35Hz (24dB/oct.)
Remote control
Yes
Yes
Adjustable BASS BOOST level
oto +9dB (50Hz)
-
Variable phase
oor180°
Maximum gauge of the speaker cables
10mm' 10mm'
10mm'
7AWG
7AWG
7AWG
Maximum gauge of the power cables
35mm' 35mm'
35mm'
2AWG 2AWG
2AWG
Fuse(s)
2 x 25A 1 x 25A
2 x 25A
Protections
Short-circuit Short-circuit
Short-circuit
Thermal overload
Thermal overload
Thermal overload
Overvoltoge Overvoltage
Overvolloge
Polarity reversal
Polo rity reversa I
Polarity reversal
Dimensions (HxLxW)
1.77x11.81x7.87" 1.77x8.66x7.87"
1.77x11.81x7.87"
(45 x
300 x 200mm)
(45 x
220 x 200mm) (45 x 300 x 200mm)
Due to constant technological advances, Focal
reserves its right 10 modify the product technical specifications without notice.