TView Pro AV User's Manual Rev 2.01
34
Appendix D - Component output
All versions of the Pro AV support two user selectable forms of component output. The TView Pro AV is factory
configured for Betacam component (Y, R-Y, B-Y) and RGB (without 7.5 IRE units of video setup). In addition,
component output synchronization may be provide as a separate, composite sync signal (4 wire) or as composite sync
signal on the green output (3 wire). Other amplitudes of component output ( i. e. M II) are available by special order.
To Next Page
Loading...
