Fonexion ideus ITCOMBO100 - Tone Setup; Handset Name; Auto Answer

USER GUIDE
EN
41
ITCOMBO100
Press the direction keys key to select the INT RING and EXT RING setup.
Press SET/OK key to conrm.
Press the direction keys to select the MELODY and VOLUME setup.
If select MELODY
Press SET/OK key to conrm.
Press the direction keys to select desired melody, the corresponding melody sound can
be heard with the selection.
Press SET/OK key to conrm your selection.
If select VOLUME
Press SET/OK key to conrm.
Press the direction keys to select desired ringer volume 1- 5, if you want to switch off
select OFF.
Press SET/OK key to conrm your selection.
TONE SETUP
The user is able to change the handset tone settings.
Press SET/OK key, then using the direction keys to select TONE SETUP item.
Press SET/OK key to enter.
Press the direction keys to select the KEY TONE and BATTERY LOW, RANGE ALARM
setup.
Press SET/OK key to conrm.
Press the direction keys key to select the ON or OFF to enable/disable the sounding of
the beep respectively.
Press SET/OK key to conrm your selection.
Notes: If you turn the tone on for key tone, a beep for key tone will sound when a key is pressed
on the handset keypad in idle state. If you turn the tone on for battery low warning, a beep will
sound when the battery is low. If you turn the tone on for the out of range warning, a beep will
sound when the handset goes out of range of the base unit.
LANGUAGE
The handset will support up to 8 pre-dened languages.
Press SET/OK key, then using the direction keys to select LANGUAGE item.
Press SET/OK key to enter.
Press the direction keys key to select the language. Each language will display in its own
native translation.
Press SET/OK key to conrm your selection.
HANDSET NAME
The operation will allow the user to change the handset name
Press SET/OK key. Using the direction keys to select HS NAME
Press SET/OK key to enter.
Enter the handset label.
If you make a mistake, press R/CLR key to correct.
Press SET/OK key to conrm it.
AUTO ANSWER
The Handset can be set to answer an incoming call automatically by simply pick it up from the
charging cradle. The user is able to select to enable/disable the auto answer function.