To Next PageTo Next Page
Need help?Do you have a question about the ForceDoor FS 1000 and is the answer not in the manual?
Close the garage door, measure width, mark centre, and mount wall bracket 2-15cm above door on inside wall.
Assemble battery and bracket, then join battery to opener. Suitable for Lead-acid batteries.
Assemble battery to the side of the opener, then join battery to opener. Suitable for Lead-acid & Lithium batteries.
Set the open and close limits for the door opener by navigating through the programming mode.
Adjust the force setting for the door opener, which is normally set automatically during programming.
Configure the travel speed of the door opener, noting that changes may cancel previous travel limits.
Set the auto-close timer for the garage door opener, recommending photo beams for safety.
Configure the condition for automatic closing, choosing between open limit position or any position.
Set the delay time for the LED light to turn off after operation, from 1 to 9 minutes.
Adjust the reversal height, where '0' means rebound to open limit, and '1-9' mean rebound to partial travel.
Set the partial open function or its height position, from '0' (closed) to '1-9' (partial open height).
Configure if all 4 buttons control one opener or only coded buttons control the opener.
Set the quantity of remote codes that can be stored, up to a maximum of 50.
Set the reversal height ignorance for obstacles in the closing path, suitable for snowy conditions.
Configure the pass door function as normally open ('0') or normally close ('1').
Enable or disable the photo cell function, ensuring it's disabled if no photo beams are fitted.
Set the operation cycles count for the maintenance alarm notification.
Details on using external push button switches for opener operation via O/S/C terminals.
Connect photo beams as shown in figures, ensuring caution light is under 25W.
Connect external push buttons (PB) as Normally Open (NO) for switch control.
Using O/S/C interfaces for adding external open/close buttons to the door opener.
Connecting flash lights (24v-35v) to the opener, using an adapter for AC 220V lights.
Ensures the door only opens when the small pass door is closed.
General| Brand | ForceDoor |
|---|---|
| Model | FS 1000 |
| Category | Door Opening System |
| Language | English |
