Ford 1964 F-100 User Manual

PART 2-2-F- AND P-100 SERIES BRAKE SYSTEMS
2-15
rear end of the cylinder and remove
the stop plate, piston, cup, spring,
check valve, and seat from the cyl-
inder bore. If necessary, blow
through the forward bolt to remove
the parts.
ASSEMBLY
1. Dip all parts except the master
cylinder body in clean hydraulic
brake fluid. Use only heavy-duty
brake fluid.
2. Install the brake fitting, bolt,
and gaskets (Fig. 12 or 13), on the
forward end of the cylinder. Attach
the stoplight switch to the brake
bolt.
3. Install the valve seat, check
valve, spring, cup, piston, and stop
plate in the cylinder bore. Install the
snap ring in the rear end of the bore.
BRAKE BOLT
FILLER CAP
STOPLIGHT
SWITCH
MOUNTINGS-
BOLT
PISTON
RETURN / SNAP
•I'-'f-li-:'": RING BOOT
STOP PLATE
BRAKE PEDAL ASSEMBLY
FIG. 13-P-100 Brake Master Cylinder

Ford 1964 F-100 Specifications

General

Brand	Ford
Model	1964 F-100
Category	Trucks
Language	English