Create a MyKey™
To program MyKey™ on one of the keys programmed to the vehicle,
insert the key that you want to make a MyKey™ into the ignition. Turn
the ignition on. Use the message center buttons or the select/reset stem
to do the following:
1. Press SETUP or select/reset stem until PRESS RESET TO CREATE
MYKEY is displayed.
2. Press and release the RESET button, or press and hold the select/reset
stem until HOLD RESET TO CONFIRM MYKEY will be displayed.
3. Press and hold the RESET button or select/reset stem for two seconds
until MARK THIS AS RESTRICTED is displayed.
4. Wait until KEY RESTRICTED AT NEXT START is displayed.
MyKey™ is successfully programmed. Make sure you label it so you can
distinguish it from the admin keys. Note: To program the optional
settings go to Step 2 in the Programming MyKey™ pptional settings
section. If your vehicle is equipped with remote start, see the Using
MyKey™ with Remote Start Systems section.
Note: The MyKey™ can be cleared within the same key cycle that it was
created, otherwise a standard key (administrator key) is required to
disable the MyKey™ programming. To clear all MyKeys™ go to Step 2 in
the Disable MyKey™ section.
Programming MyKey™ optional settings
Turn the ignition on using an admin key. To program the optional
settings, use the message center buttons to do the following:
1. Press SETUP or select/reset stem until RESET FOR MYKEY
SETTINGS is displayed.
2. Press and release the RESET button or select/reset stem to display
MyKey™ setup menus. The first menu shown is:
MYKEY MAX MPH <80 MPH> OFF
3. If you don’t want to change the maximum speed setting, press the
SETUP button or select/reset stem to display the next menu. The
remaining menus appear as follows with the default settings shown:
MYKEY MPH TONES 45 55 65 <OFF>
MYKEY VOLUME LIMIT <ON> OFF
MYKEY ADVTRAC CTRL ON <OFF>.
Locks and Security
126
2010 F-150 (f12)
Owners Guide, 1st Printing
USA (fus)
To Next Page
Loading...
