NO KEY DETECTED (if equipped) — Displayed if the intelligent
access key is not detected by the system in the following three scenarios:
•When the start/stop button is pressed in an attempt to either start the
engine or cycle through the ignition states.
•When the engine is running and a door is opened then closed.
•When the vehicle’s speed exceeds 10 mph (16 km/h) for the first time
after starting. Refer to Push button start system in the Driving chapter
for more information.
PRESS BRAKE TO START (if equipped) — Displayed when the
start/stop button is pressed without the brake pedal being applied. This
is a reminder that the brake pedal must be applied when the start/stop
button is pressed in order to start the engine.
RESTART NOW OR KEY IS NEEDED (if equipped) — Displayed
when the start/stop button is pressed to shut off the engine and a
Intelligent Access Key is not detected inside the vehicle. Refer to Push
button start system in the Driving chapter for more information.
SPEED LIMITED TO 130 KM/H — Displayed when starting the
vehicle and MyKey™ is in use and the MyKey speed limit is on. Refer to
MyKey™ in the Locks and Security chapter for more information.
SPEED LIMITED TO 80 MPH — Displayed when starting the vehicle
and MyKey™ is in use and the MyKey speed limit is on. Refer to
MyKey™ in the Locks and Security chapter for more information.
STARTING SYSTEM FAULT — This message is displayed when there
is a problem with your vehicle’s starting security system; your vehicle
will not be able to start. See your authorized dealer for service.
VEHICLE AT TOP SPEED OF MYKEY SETTING — Displayed when
a MyKey™ is in use and the MyKey speed limit is on and the vehicle
speed is 80 mph (130 km/h). Refer to MyKey™ in the Locks and
Security chapter for more information.
VEHICLE NEAR TOP SPEED — Displayed when a MyKey™ is in use
and the MyKey speed limit is on and the vehicle speed is approaching
80 mph (130 km/h). Refer to MyKey™ in the Locks and Security
chapter for more information.
BLIND SPOT NOT AVAILABLE SENSOR BLOCKED (if equipped)
— Displayed when the blind spot information system/cross traffic alert
system sensors are blocked. See Blind Spot Information System
(BLIS威) with Cross Traffic Alert in the Driving chapter.
BLIND SPOT SYSTEM FAULT (if equipped) — Displayed when a
fault with the blind spot information system has occurred. Contact your
authorized dealer as soon as possible.
Instrument Cluster
28
2011 Edge (edg)
Owners Guide, 2nd Printing
USA (fus)
To Next Page
Loading...
