Note: For all vehicles with remote start installed, it is possible to
program all original vehicle keys as MyKeys™, in which case, you will
need to use your remote start system to reset all MyKeys™ as admin
keys by doing the following:
1. Enter the vehicle, close all doors.
2. Remote start the vehicle using your remote start fob.
3. Follow Steps 1-4 in the Clear MyKey™ section.
Troubleshooting
Condition Potential Causes
Can’t create a
MyKey™
• Key in the ignition is already a MyKey™
• Key in the ignition is the last remaining admin key
(there always has to be at least one admin key)
• SecuriLock威 Passive Anti-Theft System is disabled
or in unlimited mode
• Vehicle has been started using a remote start
system that is programmed as MyKey™. Refer to
Using MyKey™ with Remote Start Systems
section.
Cannot program
the MyKey™
optional settings
• Key in the ignition is a MyKey™
• No MyKeys™ are programmed to the vehicle.
Refer to Create a MyKey™ section
• Vehicle has been started using a remote start
system that is programmed as MyKey™. Refer to
Using MyKey™ with Remote Start Systems
section.
Cannot clear
MyKey™
• Key in the ignition is a MyKey™
• No MyKeys™ are programmed to the vehicle.
Refer to Create a MyKey™ section
• Vehicle has been started using a remote start
system that is programmed as MyKey™. Refer to
Using MyKey™ with Remote Start Systems
section.
Lost the only
admin key
• Purchase a new key from your authorized dealer
Locks and Security
95
2011 Escape (204)
Owners Guide, 1st Printing
USA (fus)
To Next Page
Loading...
