Clearing a HomeLink姞 device
To erase programming from the three HomeLink威 button s press and
hold the two outer HomeLink威 buttons until the indicator light begins to
flash. The led will begin flashing in 10 to 20 seconds, at which time both
buttons should be released. Programming has now been erased, and the
led should blink slowly to indicate the device is in train mode when any
of the three HomeLink buttons are pressed.
FCC and RSS-210 Industry Canada Compliance
This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications to your device not expressly approved by the
party responsible for compliance can void the user’s authority to operate
the equipment.
192 Universal Garage Door Opener
2013 Explorer (exp)
Owners Guide gf, 2nd Printing
USA (fus)
To Next Page
