Ford 8N-8NAN User Manual

Procedure for rebushing axle spindles, including removing and installing new bushings.

Steps for removing and replacing the axle center pin bushing to ensure proper alignment.

Guidance on adjusting steering gear backlash and performing a complete overhaul.

Method for adjusting sector mesh backlash on Model 8N tractors for proper steering.

Procedure to adjust worm shaft bearing end play on Model 8N tractors.

Detailed steps for overhauling the steering gear unit on Model 8N tractors.

Specific adjustment steps for later Model 8N tractors after serial 216988.

Procedure for adjusting sector arm backlash after wormshaft bearings are set.

Procedure for removing and reinstalling the engine and clutch as a unit.

Steps for removing and reinstalling the engine cylinder head, including tightening.

Servicing of engine valves, including guides, seats, springs, tappets, and rotators.

Procedures for timing gear cover removal and camshaft installation/removal.

Service for pistons, connecting rods, rings, sleeves, and pins.

Details on crankshaft bearing service, oil seals, and journal specifications.

Servicing of flywheel, oil pump, oil pan, and carburetor systems.

Details on the governor's function and procedures for setting engine speed limits.

Steps for disassembling, inspecting, and reassembling the engine governor unit.

Information on generator types, voltage regulator settings, and cut-out relay adjustments.

Details on the Ford starter motor and switch assembly, including its function.

Explanation of the battery ignition system and distributor mounting.

Procedure for setting the engine timing using the distributor and timing marks.

Steps for overhauling the distributor, including cleaning and renewing parts.

Description of the magneto ignition system used on some 2N tractors.

Procedure for timing the magneto by aligning the impulse coupling trip point.

Steps for overhauling the magneto drive adapter assembly.

Adjusting the clutch pedal free travel for proper engagement and disengagement.

Procedures for removing and reinstalling the clutch assembly from the tractor.

Procedures for removing and reinstalling the clutch assembly from the tractor.

Steps for draining and separating the transmission unit from the tractor.

Service procedures for shifter rails, forks, and related components.

Procedures for overhauling the mainshaft, including bearing adjustment.

Procedure for removing and servicing the main drive gear (clutch shaft).

Service procedures for the countershaft, including bearing adjustment.

Procedure for removing and reinstalling the reverse idler gear.

Steps for removing the differential unit from the rear axle center housing.

Procedures for overhauling the differential, including case and gear servicing.

Information on removing and servicing the main drive bevel pinion and ring gear.

Procedure for removing the bevel ring gear from the tractor.

Steps for adjusting axle shaft bearings for proper end play.

Procedure for renewing wheel axle shaft bearings.

Procedure for removing and overhauling the PTO external shaft.

Steps for removing the PTO shifter and front bearing unit.

Procedures for removing, overhauling, and installing the belt pulley unit.

Adjusting quadrant and control springs for proper lift arm operation.

Adjusting constant draft and position control springs for precise implement control.

Procedures for removing, disassembling, and overhauling the lift cover assembly.

Diagnosing and resolving common problems with the hydraulic lift system.

Procedures for removing, installing, testing, and overhauling the hydraulic pump and its components.